Layer 2 access with traditional multilayer campus design.Multigigabit Ethernet (mGig) and PoE at the access-layer.Cisco Digital Network Architecture (Cisco DNA).Definition and Introduction: Campus LAN and Wireless LAN.If we are facing any issue with the connection then we must make sure that the basic configuration is correct. If we have connected the routers via serial connection then make sure that both routers are using the same language or protocol as a mismatch of the protocol will not let the line come online.
While configuring the serial connection, we must also enable the clocking on the DCE side as this is required for the serial connection. The IP address assigned to the router should be from the same subnet and after assigning the IP address, we have to bring the interface up using the ‘no shutdown’ command.īy default, interfaces of routers are administratively down.
To bring up the connection between routers, we have to follow two steps Once we have connected the router with the correct port and cable then we can bring up the connection, we have to configure the IP addresses on the connected interfaces. The serial connection can also be used to connect two routers in which we have to configure the DTE side of the router while the DCE interface will be configured by the service provider however in packet tracer we have to configure both sides. Again, a crossover cable must be selected to connect the routers. We must use a crossover cable in this connection as well.Ī Gigabit Ethernet connection can be established using both Ethernet and fiber optic cable. Using the other cable will not work.įast Ethernet connection can be established using the Ethernet cable or fiber optic cable however fiber optic cable uses different types of connectors. We have to use a crossover cable for the connection between two routers when connecting the routers using an Ethernet port. The following type of connection can be configured to connect routers.Īn Ethernet connection can be established using the Ethernet cable which connects to the RJ45 connector on the routers. We can connect two Cisco routers using various types of available connections on the router so both routers should have the same connection available to establish the connection.
While designing a network in the packet tracer, we must know the basics of network devices so that we can configure them easily and as per our requirements.Ĭonnecting two routers is not hard however configuration varies according to the setup and the technology used in the connection. How to connect two routers in a Cisco packet tracer using different types of connections
0 kommentar(er)
